Message
par Teddyman » 09 juin 2019 09:03
ta sonde lambda sur le 1er cata (DP) qui est HS
"This diagnostic trouble code (DTC) is a generic powertrain code, which means that it applies to OBD-II equipped vehicles, including but not limited to Toyota, VW, Ford, Dodge, Honda, Chevrolet, Hyundai, Audi, Nissan, etc. Specific repair steps may vary depending on the model.
A P0031 DTC (diagnostic trouble code) refers to the O2 sensor (oxygen sensor) located on Bank 1 in front of the catalytic converter. There is also an oxygen sensor behind the converter which is Sensor #2. This O2 sensor #1 may also be refered to as an air/fuel ratio sensor since on some vehicles it is. It detects the amount of oxygen in the exhaust gas compared to the outside air and then vehicle's computer adjusts the air/fuel ratio going into the engine. The sensor is less effective when the exhaust gas temperature is low, so it includes a heater which is activated to help get better readings from the A/F O2 sensor. Essentially this P0031 code means that the resistance of the heater circuit is lower than normal. In most cases, that resistance level must fall below 0.8 A to trigger the DTC code.
Read more at:
https://www.obd-codes.com/p0031
Copyright OBD-Codes.com"
Mazda 3 MPS Truered 2008
moteur : collecteur Xs Power V3, Inlet COBB+SRI CPE- CAB cork, TP Cork, Forge V1, Banjo Bolt, Denso ITV22, EGR block plate, OCC Saikou michi stage II+PCV+VTA, kit JBR BS delete, support filtre mazda Gen2+plaque prosport, joint Toyota injecteurs, joint papillon et collecteur admi JBR, interne pompe autotech et Reprog by "El sorcier" + MEP
chassis : support AWR, SB train AV Powerflex et Whiteline, double cross floor BAR AR speedline sup., BAR inf. AR COBB , durites avia Hel carbolook+RBF600, cales 15mm AV+AR made in china mais top qualité
autres : Eonon Ga 5151F + A0110, TT Blitz, Dashhawk+support CPE, AB AR blanc, ventpod Fundream+mano depo racing 3 in 1, Xénon 5000K 35w, intérieur cuir topgaiters, catadioptre PC AR noir, balai essuie glace AR delete...
ca va marcher mais il y aura un voyant au tableau de bord, donc pour le CT c'est dead...